Talex SPRINTER 1500, Original User Manual, Page: 85 / 129

85
jammed. Check dispenser bearings,
sprockets and gears and
replace if necessary.
Irregular bale shape.
Reduce the rotational speed
during wrapping. Ensure
correct bale formation.
Film parts stick with each other in
the wind.
Check the film tension.
Rotational speed too high.
Reduce the rotational speed
during wrapping
Bale wrapping
asymmetrical.
Incorrect dispenser height.
Adjust the height of the film
dispenser to suit the bale size.
The bale falls off the
machine during
wrapping.
Rotational speed too high.
Reduce the rotational speed
during wrapping.
Terrain slope too high.
Carry out wrapping on level
fields if possible.
Irregular bale shape.
Ensure correct bale formation
/ reduce the wrapping speed.
Film is not cut Blade damaged or blunted
Replace the cut and hold
blade.
Cut and hold does not
hold film or lets it go too
fast.
Film does not hit the correct grab
position.
Adjust the position of the cut
and hold frame on the
turntable.
Film is released before a new cycle
begins.
Check the hydraulic
accumulator pressure and
adjust if necessary.
10. Disassembly, disposal and environment protection
In the event the machine is worn to the extent which prevents its further use, it should be scrapped.
This also applies to regular repairs and replacement of damaged parts. Clean the machine thoroughly
before scrapping. Drain oil from the machine and have the machine decommissioned. Next,
disassemble the machine by segregating its parts based on the applied materials. Segregated parts
should be transported to a scrap yard or disposed of.
The machine is 100% environmentally friendly. 98% of the materials used in the production process
are recyclable. Worn machine parts must be disposed of in line with the local environment