Talex SPRINTER 1500, Original User Manual, Page: 47 / 129

Page 47 of 129
SELF-LOADING BALE WRAPPER
SPRINTER 1500
6.8 Film installation
Figure 31 Film installation
(1) roller unit, (2) jam nut, (3) pressure screw, (4) lower holder cone, (5) upper holder cone
To install the film roll, follow the procedure below, maintaining the sequence:

Clean and lubricate the roller unit (1) of the dispenser using silicone spray.

Swing the roller unit (1) out.

Loosen the jam nut (2).

Lower the lower holder cone (4) by removing the pressure screw (3).

Position the film roll onto the holder cones (4) and (5), starting from the upper cone (5).
- The roll must be aligned with the cone centreline.

Move the lower holder (4) by screwing the screw (3) upwards.

Secure the position of the pressure screw (3) with the jam nut (2).

Unroll the initial section of the film.

Turn the roller unit (1) in such a way that one of them rests on the film.

Thread the section of film you unrolled through the rollers according to the diagram shown on
the dispenser decal (Figure 32).