Talex SPRINTER 1500, Original User Manual, Page: 10 / 129

Page 10 of 129
SELF-LOADING BALE WRAPPER
SPRINTER 1500

After the first hour of operation, check all disjoint connections like bolt and pin connections,
etc.

The bale wrapper should be stored on a flat, level, paved surface, out of the reach of
bystanders and animals. Use the support foot for stabilising the bale wrapper.

Exercise caution during the mounting and dismantling of the bale wrapper, and pay
particular attention to the structural components through which the machine is connected
with the vehicle.

Before the operation, check the condition of the machine and of the vehicle it is attached to.
Ensure the vehicle and bale wrapper are in good technical condition. Any worn or damaged
parts must be replaced immediately.

The bale wrapper must be equipped with all the safety guards (provided by the
manufacturer), preventing access to any moving parts. The guards must be complete and
fully operational.

It is not allowed to work with the bale wrapper without safety guards. It is not allowed to
work with damaged safety guards.

It is not allowed to lift the grab arm when the rotary frame drive is engaged.

Before beginning to work with the machine, learn how to operate it by reading this
Instruction Manual taking into account occupational safety rules and recommendations for
maintenance and adjustment.

The Instructions Manual must be kept with the machine. If you loan the machine for use,
ensure that it is in good technical condition and that it is complete with the Instructions
Manual.

Do not attach additional transport means to the machine.

During commissioning, check the machine functions and make the initial adjustments.

Due to the natural wear and tear the state should be controlled, using the recommendations
described in Section
9 „ Maintenance Maintenance”.

When taking over and transporting the machine, inspect its technical condition to check for
damage.

Standing under the raised grab arm is not allowed to prevent being crushed by the
components of the machine.

When adjusting, keep your fingers and limbs away from the structural parts of the machine.

It is forbidden to leave a tractor’s cabin when the machine is running, and before all the
rotating parts have stopped.

The operator of the vehicle working with the bale wrapper must ensure that no person is
approaching the machine during its operation, and the distance of at least 50 m from the
working bale wrapper is always maintained.

Before you start wrapping, check that the rotary frame and other structural components will
not collide.

Ensure suitable visibility when u-turning, reversing or manoeuvring the machine, or ensure
assistance from a properly trained person.

When connecting the hydraulic hoses, make sure that the hydraulic system is not
pressurised.

Do not stay between the vehicle and the machine when the vehicle engine is running.

Working on slopes exceeding 5% is not allowed.

Exercise particular caution when working on slopes.