![background image](http://html1.mh-extra.com/html/takeuchi/tb1160w/tb1160w_operators-manual_3334848250.webp)
6-4
TROUBLESHOOTING
IF THE ENGINE OVERHEATS
• Do not open the engine hood when
steam is coming from it. The steam or
hot water may spurt out and cause
burns.
• Do not remove the radiator cap or the
drain plug when the coolant is hot. Stop
the engine and wait until the engine and
the radiator cool. Then, slowly loosen
the radiator cap to release the internal
pressure.
• Before performing maintenance, stop
the engine and allow the machine to
cool down.
• Before performing maintenance on top
of the work bench, clean the footing and
observe the following precautions to
prevent falling.
· Do not spill oil or grease.
· Do not leave tools scattered around.
· Watch your step when walking.
• Never jump down from the machine or
the work bench. When getting on or off
the machine or work bench, use the
steps, handrails or work bench to
support your body. Your weight should
be evenly distributed among the three
contact points (one hand and two feet
or two hands and one foot).
• Do not stand on the dozer blade and
perform maintenance work. Doing so is
dangerous because of the unsteady
foothold. Use the work bench.
The symptoms listed below indicate
overheating.
IF THE ENGINE OVERHEATS
• An alarm is sounded and the vehicle/
engine emergency lamp and the coolant
temperature warning lamp start flashing.
• The water temperature gauge needle is in
the red zone.
• Steam comes from the engine room.
Summary of Contents for TB1160W
