TAJIMA TLMX Series, User Manual

Page: 153 / 318

To trim thread
138
Chapter 6
RR05
2-3. To trim thread automatically (LM head)
This is the setting for trimming thread. (Upper thread is not trimmed.)
2-3-1. Explanation on the screen
[a]
To trim thread automatically
YES: To trim
NO: Not to trim thread
[b] Number of lowering the needle bar by slow operation at start after thread trimming or after data
set
[c] Tie stitching at thread trimming
YES: To perform
NO: Not to perform
[d]
Stitch length of the above [c]
When "N" is displayed, the value differs in each needle bar.( → p.163)
2-3-2.
How to operate
The following is an example that thread is trimmed automatically and the number of inching after ATH is set
to "3".
(1)
To open screen
(2)
To trim thread automatically
F2
YES
8 ATH (LM)
YES/NO
Inching after ATH
4
2
A
9
Tie Stitch
Tie Stitch Length
N
0.6
/
0.8[mm]
[b]
[c]
[d]
[a]
To trim thread automatically
Number of lowering needle bar at slow operation
Tie Stitch
Tie Stitch Length
YES/NO
8 ATH
YES