Chapter 2 Hardware Installation
21
2.4
Cable Connection
2.4.1
Connecting the Power Source
VENUS 29xx accepts 100V~230VAC/50~60Hz (Auto-range) power source.
Connect the device to a power outlet of the correct voltage and rating as your
power system.
2.4.2
Connecting the IP Network via Ethernet
On the base unit of VENUS 29xx Series, the embedded 10/100Base-T Ethernet
port is provided as the standard interface to the IP network. The pin layout of the
RJ-45 connector for IEEE 802.3 standard 10/100Base-T Ethernet ports are defined
as following:
Table 2-2
10/100Base-T Connection
Pin #.
Pin Function
Pin #.
Pin Function
1
TD+
5
N/C
2
TD-
6
RD-
3
RD+
7
N/C
4
N/C
8
N/C
For connecting the 10/100Base-T Fast Ethernet, a Category 5 unshielded
twisted-pair (UTP) cable or shielded twisted-pair cable is used. Two pairs of the
twisted wires are used for separated Rx (reception) and Tx (transmission). The
Fast Ethernet port is backward compatible with traditional 10Base-T Ethernet.
VENUS 29xx Series can automatically detect whether it is connected to a
10Base-T or 100Base-T Network.
Note:
It is strongly recommended to use an AC power cord with
Grounding pin or connect the Grounding Screw on the rear
panel to the grounded supply of correct power system.
Summary of Contents for VENUS 2916
