Tadiran Telecom Coral FlexiCom CoraliPx FlexSet-IP 280S, Installation Manual

Page: 42 / 98

34 Phone Hardware Description Coral FlexSet-IP 280S Installation Manual
Coral FlexSet-IP 280S Installation Manua
l
4
Wall Mounting Using Wall LAN Socket
In some countries the wall LAN socket is equipped with two pins for wall mounting.
In such a case, there is no need to use the three screws and wall plugs included in the
wall mount kit.
Figure 17 Wall Mount
Bracket (Using Wall LAN
Socket Pins)
To wall mount the phone using the wall LAN socket:
1
Use the cut outs (D) to algin the Wall mount bracket with the pins that are
attached to the wall socket, and then slide it down into place.
2
Insert the two rubber bumpers into upper holes (see Figure 13 on page 31 ).
3
Connect the PC (if required) and LAN cord(s) and feed them into the groove
located at the top of the phone’s back.
It is recommended to use a 4-6 inch (10-15 cm) LAN cord (not supplied)
when connecting directly onto a wall LAN socket pins.
4
To mount the telephone on the wall, place the slots on the bottom of the phone
(A) towards bottom legs of the bracket, and snap them in place, as shown in
Figure 14 on page 32 .
5
Snap the legs, located on the top of the bracket, into the matching slots (B) at
the top of the phone (see Figure 14 ).
6
Lift and remove the handset hook (tab), rotate one half turn (180 degrees) and
reinsert it into the cradle of the telephone set, with the projection at the edge
tab extended out. Then place the handset (see Figure 15 on page 32 ). The
rotated handset hook secures the handset in an upright position.
Figure 16 on page 33 shows the side view of a wall-mounted FlexSet-IP 280S.
Top and
bottom
pins
Central Cutout
for Wall Socket
and Line Cord
(C)
Middle
Cutouts
(D)
Wall Jack Wall Mounting Bracket