INSTALLATION INSTRUCTIONS
NI TB-2630
Terminal Block for the NI PXI-2530
This guide describes how to install and connect signals to the
National Instruments TB-2630 terminal block to configure your
NI PXI-2530 switch module as one of the following:
•
128 × 1 1-wire multiplexer
•
64 × 1 2-wire multiplexer
•
32 × 1 4-wire multiplexer
•
Eight 16 × 1 1-wire multiplexers
Refer to the
NI Switches Getting Started Guide
to determine when to install
the terminal block.
Introduction
The TB-2630 terminal block installs in front of the PXI-2530 switch
module. The TB-2630 has ribbon cable headers to connect signals to the
switch. Screw terminals for the trigger input and trigger output signals also
are available.
Conventions
The following conventions are used in this guide:
»
The
»
symbol leads you through nested menu items and dialog box options
to a final action. The sequence
File»Page Setup»Options
directs you to
pull down the
File
menu, select the
Page Setup
item, and select
Options
from the last dialog box.
This icon denotes a note, which alerts you to important information.
̭͈Ρ΅νιϋΠ͉ͅȂུࢊβȜΐ͜܄̞̳ͦ̀͘͘ȃ
