3.4.1 System
Figure 3-13 System Configuration Interface
See Figure 3-13 for the System Configuration interface which implements the hardware
configuration of the recording server. The table below explains the above items in Figure 3-13.
Item
Description
Board Serial No.
Serial number of ATP series board (read-only).
Total Number of
Channels
Total number of channels in the system (read-only).
Line Voltage
Ignored or Not
Sets whether to ignore the voltage detection result on the line.
Range of value: 0: Not to ignore (default); 1: Ignore.
On-/off-hook
Threshold Voltage
Sets the threshold voltage (calculated by V) judging the on-/off-hook operation
on the recording channel of ATP boards. The default value is 16.
Sets the gain of input signals on the analog recording channel.
Range of value: 0: Normal gain (0DB); 1: Increased gain (20DB). Currently only
the value 0 is supported.
Input Gain
Default Recording
Volume
Sets the gain of the recording volume.
Range of value: -7~6, a value greater than 0 denotes volume increasing, while
a value less than 0 denotes volume decreasing; -7 denotes turning off the
volume. The default value is 0. This value multiplying 3 equals the DB value.
Bargein Sensitivity
Sets the sensitivity of the Barge In detector.
Range of value: 0~31, with the default value of 6. A higher value indicates
greater sensitivity.
Bargein Threshold
Time
Sets the minimum signal duration for the Barge-in detector.
Range of value:
16 and must be the multiple of 16, calculated by millisecond
(ms), with the default value of 32.
DTMF Reception
Sensitivity
Sets the minimum durations of the DTMF signal at on and off states.
Provided the value of this configuration item is n.
n is comprised of 8 bits (namely Bit7…Bit0). Below is the meaning of each bit:
Bit3~Bit0: The minimum duration of the DTMF signal at on state. Range of
value is 1~6 and the unit is 16ms, with the default value of 3;
ATP2410 User Manual (Version 4.0.0.0)
Page 18
