Syntec 70SB, Manual

Page: 10 / 46

自動化產品
/Automation Products
–
70SB Laser Marking Machine Assembly Manual(Discontinued)
Wiring – 10
6 Wiring
6.1 Galvanometer wiring
A 15-pin wiring is used to connect the controller and the galvanometer. Please use standard wires from
Syntec instead of using unclear wires.
6.1.1 2D Galvanometer Module
6.2 Laser source wiring
The controller is equipped with 25pin wire to the laser source, which can directly support the laser
source on the market, including laser sources from IPG, Brimo, Raycus, and Chuangxin
If you want to go with a SPI laser, you need to make extra wire. You can define the wiring according to the
pin.
If the laser source is not a standard 25pin, wiring must be made according to the interface of the laser
source. Thus, the following provides the definition of the Syntec 25pin interface, as well as its
representative significance.
Wiring can be used as required; please refer to interface definition.