Syntec 70SB, Manual

Page: 37 / 46

自動化產品
/Automation Products
–
70SB Laser Marking Machine Assembly Manual(Discontinued)
Exterior motor setting – 37
Check connection in controller
Path:
【
F10
】
Next page →
【
F1
】
PLC →
【
F3
】
PLC S Bit → ( S99 )
To check, whether the Dipole connection is in progress. This bit is set to FF when any remote program is
connected to the core; this bit is set to 0 when no remote program is connected.
Connect success : S99 = FF
Connect fail: S99 = 0
Start
After check the connection.
There will be shown controller information and its IP address.
It's free to click any function that you want to use.
Notice: If you need to reconnect to other IP address, just close AnalysisPlatform.exe then open again.
10.6 Analysis Platform setting
There are three value needed to be adjusted.
First, power type - single phase
Second, encoder number
Third, encoder resolution