Section V
Control Interface Details
006-0006885 08/14/18
Rev H
38 of 48
MINV-4000-1U-28 Guide www.synqor.com
Synchronized Operation of Multiple Units
Interconnecting multiple units via the Configuration port using the various CONFIGURATION
cables enables synchronized start-up and shutdown of connected units.
Turn-On, Turn-Off, Restart Control:
When a MINV device is in the Standby Mode (input power applied but output not enabled), and its
output is enabled via the front panel switch, remote enable input, or serial command, all other MINV
devices that are also in the Standby Mode will enable their outputs at the same time. This feature
is enabled by default when the CONFIGURATION cables are utilized to interconnect multiple MINV
devices. This feature can be disabled via the serial interface using the
SYNCCON OFF
command, and
this setting is stored in non-volatile memory. This feature can also be disabled via the web interface.
When a unit is operating and its output is running, if its output is disabled via the front panel
switch, remote shutdown input, or serial command, all other MINV devices that are operating will
remain enabled, if those remaining MINV devices can support the present load. The
SYSTEM DISABLE
command will allow a synchronized shutdown of all MINV outputs.
