Synel SY-760, User Manual

Page: 22 / 106

-
20
holes (A).
Step 4:Drill holes using a 6 mm. (1/4”) drill bit.
Step 5:The cables can be wired through the wall and positioned in the clasps (C) to the bottom of the terminal where
that are connected, or be wired directly from the bottom of the terminal (D).
Step 6:Position the panel so that all of the wires are in place and screw the panel to the wall.
Step 7:Wire all of the cables through the mounting panel and position the electric socket in it’s place in the mounting
panel (F).
Step 8:Connect the communication cables to the terminal.
Plug one end of the communication cable into the communication socket of the terminal. If an internal modem has
been added and the modem is used, plug the RJ-45 connector of a standard telephone cable into the telephone line.
Do not use the communication cable.
Step 9:Slide the terminal into place.
Step 10:Screw the security fastener into place (E).
Live wires in the vicinity may contain 115V or 220V.
Make sure not to drill into any live electric wires. Overlooking this warning may result in harmful contact with an electrical
current.