10. Inspection and maintenance before riding
18
9
﹙
Checking front brake lining
﹚
﹙
Checking oil quantity in the master cylinder
﹚
Check the brake from behind the brake
caliper. The brake pad must be replaced with
new lining when the brake pad wear limit
reaches the brake disk.
Park the scooter on a level ground, and check
if fluid level is under the “LOWER” mark.
Recommended Brake Fluid: BRAKE OIL (
DOT
3 or DOT4
).?
﹙
Replenishment of front wheel brake fluid
﹚
1. Loosen the screws and remove the master
cylinder cover.
2. Wipe out the foreign materials, dirt around the
reservoir, being careful not to let foreign materials
fall into the reservoir.
3. Remove the diaphragm.
4. Add brake fluid to upper level.
5. Install the diaphragm, and install the master
cylinder cover.
6. Please note the diaphragm
’s direction, and do not
let foreign materials fall into the reservoir. And
tighten the master cylinder cover securely.
CAUTION:
To prevent chemical reaction, please do not use other brake fluids those not recommended.
Do not fill above the upper limit when adding brake fluid and avoid dropping on painting or plastic
components to prevent damage.
THROTTLE GRIP HANDLE CLEARANCE ADJUSTMENT
Correct clearance allows throttle vale handle to rotate 5~10
°
.
Loosen the lock nut first, then turn the adjust nut to adjust.
Tighten the lock nut securely when finished.
Check Items:
1. Check throttle
’s
valve cable to see if it can be moved
smoothly from a closed position to a wide- open position.
2. Rotate steering handle from side to side to check if the throttle
valve cable is interfered.
3. Check to see if the throttle valve cable is obstructed by other
cables preventing it from being operated smoothly.
Brake disk
Upper
Brake fluid
Diaphragm
Master
cylinder cover
Screw
Brake caliper
Brake pad wear
limit grooves
5~10
°
Fixed nut
Adjusting nut
Rubber boost
