EQUIPMENT DET
AILS
93
Truma Combination Boiler
Control Panel and appliance
instructions
Please read the user instructions before using
the heating system. The instructions include
warnings regarding the safe use of the system,
and no liability whatsoever can be accepted
for damage or injury resulting from failure to
observe the instructions.
The heating system can be controlled by a
Truma CP+ controller, or the Swift Command
control panel, App., or remote control system.
For Swift Command functions please see the
Swift Command literature and details within
this handbook.
For use of the CP Plus controller, and general
user instructions for the heating system
appliance, please read the Truma information
available at the following locations:
CP Plus Controller
https://www.truma.com/downloadcenter/
cp_plus_installation_operating_de_gb_fr_
it.pdf
Combi 4 Gas/Electric and Combi 6 Gas/
Electric appliances
https://www.truma.com/downloadcenter/
combi_e_cp_plus_ready_operating_de_gb_
fr_it_nl_dk_se.pdf
If you are unable to view the documents on
line, please contact the supplier, your dealer or
Swift for an electronic or paper copy.
Electrical Operation of Truma
Combination Boiler
Before the heating system is used for heating
using electrical (230v) energy, the 230v
isolation button on the Sargent Power Supply
Unit must be switched ON, as shown in the
image below. To confirm a supply is available,
the button will be illuminated when a power
supply (mains hook up) is connected and the
button is ON.
Troubleshooting instructions
(Combi heater)
In the event of a problem occurring, a warning
or error code will be displayed on the Truma
CP Plus control panel, along with a warning
triangle. Further warning information will also
be displayed on the Swift Command control
panel.
The following table describes causes and
remedies to the various fault codes that may
be displayed on the Truma control panel.
Please see the Swift Command instructions
elsewhere in this handbook for further detail
of error messages displayed on the Swift
Command panel.
If the Truma panel is displaying a warning
triangle, please be aware if five attempts are
made to re-start the heater, without rectifying
the problem first, the Truma control panel will
lock out for 15 minutes. During the 15 minutes
the warning triangle will flash, as opposed to
being permanently displayed.
Heating/Hot
water
Summary of Contents for Select 122
