EQUIPMENT DET
AILS
101
Cleaning
!
WARNING:
Before cleaning the
appliance always turn it off and disconnect
from power supply and wait until it has
cooled down.
!
CAUTION:
Surfaces that are still hot can be damaged
if they come into contact with cold water or
a damp cloth. Never use abrasive, corrosive
or chlorine based cleaning products. Never
use steel or plastic scouring pads. Never
leave deposits of acid or alkaline substances
(vinegar, salt, lemon juice etc.) on the
appliance. Stainless steel or enamelled
surfaces must be cleaned only with water
and soap or a neutral detergent, thoroughly
rinse and dry. Use clean sponges or cloths
to clean.
Injectors
!
WARNING:
Cleaning or replacing gas
injectors must only be performed by
authorised and qualified gas service
engineers. The manufacturer declines all
responsibility in regard.
Burner
Injector
(mm)
Stanped N.
Auxiliary
47mm
0.50
50
Semi-Rapid
0.67
67
Rapid
0.75
75
Thetford oven
!
WARNING:
Before using the appliances
for the first time, remove all accessories and
packing in the grill and oven, including any
surface protection film, i.e. plastic coating.
Clean all interior surfaces with hot soapy
water to remove any residual protective
covering of oil and rinse carefully.
!
WARNING:
Accessible parts may be hot
when the grill is used, young children should
be kept away. When cooking always ensure
young children are kept away.
Ensure the gas cylinder is turned on. In the
event of a gas smell, turn off at the cylinder and
contact supplier. The burners on this appliance
have fixed aeration and no adjustment is
required. Depending on the gas being used, the
burners should flame as follows:
Propane:
The flames should burn quietly with
a blue/green colour with no sign of yellow tips.
Butane:
Normally on initial lighting, as small
amount of yellow tipping will occur and then
slightly increases as the burner heats up.
!
WARNING:
The control tap on this
appliance operates both the grill and oven
burners. To ensure safe operation it is not
possible to operate both burners at the
same time.
Using the hob burners
1. Ensure gas cylinder/supply is connected
and turned on. In the event of a gas
smell turn off at gas cylinder/mains and
contact supplier
2. Flame supervision: Each burner is
controlled individually and is monitored
by a thermocouple probe. In the event
of the burner flames being accidentally
extinguished, turn off the burner control and
do not attempt to re-ignite the burner for at
least one minute.
3. To light: Push in the control knob and turn to
full rate - see Fig.2. Hold a lighted match or
taper to the burner and push the control knob
in and hold. It is necessary to hold the knob
THETFORD OVEN
Summary of Contents for Select 122
