ELECTRICAL SYSTEMS
61
SWIFT COMMAND POWER CONTROL SYSTEM
Swift Command Power Control
System
1. Introduction
This section of the handbook will guide you
through the operation of the electrical system.
All details are correct at the time of going to
press. Please also see the online version which
will include any later updates or amendments.
Further technical details are contained in
section 3 or in the supporting technical manual
available from www.sargentltd.co.uk
For the safe operation of all electrical
equipment within your Leisure Vehicle it is
important that you read and fully understand
these instructions. If you are unsure of any
point please contact your dealer / distributor
for advice before use.
The system has a number of key components
that you will need to be familiar with before
attempting to use the system, these are:
• The EC652 or EC653 Power Supply Unit
(PSU) - a combined mains consumer unit
and 12V controller usually located in a
storage area (lower bed box, wardrobe or
similar).
• The EC800 Control Panel (CP) - a remotely
located user control panel used to turn
circuits on and off and to display battery,
water tank and other system information.
This panel uses graphical touchscreen with
straightforward controls and reliable data
communication to the PSU.
• The PX300 Intelligent Battery charger 300W.
Summary of Contents for Select 122
