Swegon bluMartin freeAir 100, Manual

Page: 48 / 60

Installation - Unit
46 [ I ]
Piep
Device Test
1. After correct installation turn the freeAir 100 on and wait a
few minutes while the device executes a test routine.
Test Turbo operation once either only blue LEDs or no
LEDs are illuminated.
2. We recommand connecting a laptop to the
freeAir 100 with a USB cable and using the
freeAir Connect software to check the
displayed readings.
Wait a few minutes for the both filter lights to
go from blinking to staedy green. Then you can
be sure, that the pressure losses in the
ventilation ducts are low enough.
3. If desired, you can also activate the WiFi
function and / or bluHome function
of your freeAir 100 here.
Note
The WiFi function is available from software
version 2.02 and higher (update from version
1.xx to 2.xx is not possible).
www.bluMartin.de/freeair-support/wohnraumlueftung-freeair-wifi-konfiguration