Swegon bluMartin freeAir 100, Manual, Page: 47 / 60

Installation - Unit
45 [ I ]
1
2
3
Unit Insertion
1. Remove the condensate drain plug with the attached
lifter. To do this, push the drop sheet backwards with your
thumb first.
Danger
Do not remove the plug, if a condensate drain is not
connected to the hose of the wall box.
2. Clean the wall box and the outside hood with soapy
water.
Provide for the free flow of condensate (round brass
porthole behind).
Before replacing the unit, use the included silicone
lubricant and apply a thin film to the seal at the leading
edge of the wall box and at the gasket, so the device
slides easily into the wall box.
3. Support the appliance with your right hand in front and
bottom and slide it straight into the box. Slide by pressing
the front panel on the unit until it stops.
Note
The device will only be operational if seated completely
inside the wall box (if necessary beat with your hand on
the front panel).