14
8.2 Operation mode:
•
Press MODE switch to select how to operate the machine: DMX / Manual / Timer / Remote
0-10V/ switch off.
Op mode DMX Ch: 001
Op mode MANUAL
Time:00:00 smoke
Op mode REMOTE
SWITCH OFF? (OK)
P
0%
FAN
0%
>P
0%
FAN
0%
>P 0%
FAN
0%
P
0%
FAN
0%
MODE
MODE
MODE
MODE
MODE
1.
2.
3.
4.
5.
Press MODE to select how
to control the machine.
8.2.1 DMX mode:
Select DMX mode to control the machine from a DMX light desk.
1. INTRODUCTION:
The display indicates: Operation mode (DMX), programmed start channel, pump and fan
output.
Op mode DMX Ch:
001
P 0% FAN 0%
The machine uses maximum 2 channels:
Channel 1 = Output, channel 2 = fan speed.
The last stored address will be stored in the processor´s memory when the machine is
switched off and / or mains voltage is disconnected. This address is default next time the
machine is switched on. In an application where the machine is used with the same address
every time (e.g. on tour or in permanent installations), set of address is not necessary, as the
machine always start up with the same address automatically.
If, for any reason, a different address is to be used temporarily: Set the temporary address
(indicated in display window), but do not press “OK”. The machine will respond to the
temporary address until mains power is switched off. Next time it is switched on, the
common favourite address will be set as default.
2. ADDRESS PROGRAMMING:
1.
Press MENU to set a start address. Use the
▲
/
▼
buttons to select an address between 1
and 511. Press OK to store the address.
Set start address
Ch:
001
2.
Press MENU for exit.
