17
1
2
3
4
2
3
4
Input Stage
The module shows the setup of output and effect insert which are assigned from the bus.
EQ
The module shows the EQ curve of the bus.
Input Source
The module shows the channel info sent to the bus
Output Stage
The module shows the name of the bus, Pan/BAL value, Solo, Mute, delay setup, fader level and meter
By double pressing the name of the channel can be edited through the soft-keyboard popping up.
Mono Bus
Bus 1 ~Bus 4 are Mono busses.
Input Stage Subpage
The page contains Send and Insert. Bus1~Bus4 can send signal to Bus5~Bus8 and L/R master output,
Bus5~Bus8 can only send signal to L/R master output.
OUT3 indicates physical output 3 assigned to the bus, and it shows OUT if there is no bus assigned to the
physical output. Please refer to the page of Patch for operation of assigning busses to physical outputs.
22
2
Patch page
This page is mainly for selecting busses to be assigned to 8 analogue outputs, S/PDIF output and USB output.
The console has 4 mono bus (Bus 1~Bus 4), 4 stereo bus (Bus 5L~Bus 8R) and master output bus Master L,
Master R.
Default
In Default mode, Bus1- Bus 5R are assigned to OUT 1 ~ OUT 6, Master L and Master R are assigned
to OUT 7-8, S/PDIF OUT and USB OUT
Custom
Switch to custom mode after single pressing
“
Custom1 2 3
”
buttons. Single press
“ ”
of any output,
then select the bus to be assigned. Thus finish the route settings from the busses to ports.
Notice: Can only S/PDIF and USB output in pair select stereo bus or master output bus, meanwhile,
8 analogue outputs can select any one out of 14 busses.
After rebooting the system, the Patch setting is always what you set before you had powered off the
console last time.
