24
2
3
4
5
6
The Effects have 8 modules, which are 2 Modulation, 2 Delay, 2 Reverb and 2 15-band GEQ. All the
modules can be inserted to input processing channel or bus processing channel, for one time only.
Note, input processing channel can only be inserted with one effect module, while the bus can have two.
Effect module
Double press the effect module, then a subpage of parameter setting of this module pops up. Single press
the close button on the subpage to exit, and return to FX page.
Bus selection
Single press the dropdown button , and select bus (Bus1~Bus8 Master LR) from a dropdown list.
If the chosen bus has selected a FX module in the input part of the channel, then the left frame displays
Selected FX modules in order of selection from left to right. If nothing has been chosen, you could drag
the FX module above to the empty frame (if the FX module was occupied by other channel or bus, a dialog
pops up
”
The module can be used only once and it is already used by **. Are you sure you want to use
the module forcibly now
?
Yes or No
”
).
Modulation Subpage
Double press
“M
odulation1 or 2
”
button in the FX Subpage, access to Modulation parameter tuning Subpage
as below showed in the picture
Module Selection
Single press left right selection button, to choose FX module (Modul1-Modul2-Delay1-Delay2-Reverb
1-Reverb2-GEQ1-GEQ2
Type
Single press dropdown button, then choose a wanted type from the dropdown listChorus Slow/Chorus
Fast/Flanger Slow/Flanger Fast/Celeste Slow/Celeste Fast/Rotor Slow/Rotor Fast.
Dry-Wet
Ranges from 0 to 100 with a default @ 0. Adjust the parameter of Dry-Wet by dragging the slider, or
turning the main Encoder on the control panel.
15
Channel Switch
Single press the button to switch between previous or next channel on the same layer
SUM
When only one connector (Left or right) of stereo is plugged, single press the button to copy the signal
from one channel to another, then to the stereo processing channel. Press again to disable SUM. The
default is disabled.
REV
Press the button to toggle phase inversion. The default is set as normal phase.
Trim
Single press the button to enable Trim, The default is disabled. Adjust the Trim by turning the main Encoder
or on the touch screen (fine tuning can be activated by pressing the main Encoder knob). Trim ranges from
-20 dB to 20 dB, and the default is 0 dB.
HPF
Press the button to enable the HPF; the default is disabled. Adjust the frequency of HPF by turning the
main Encoder or on the touch screen (fine tuning can be activated by pressing the main Encoder knob).
The frequency ranges from 16 Hz to 400 Hz, while the default is 16 Hz.
Insert
Press the button of any effect module to insert this module before the EQ on the channel. Each effect can only
be used on one channel, and each channel can only be inserted with one effect module (the link parameter
of this module is the serial number of the channel). The busses (Bus1~Bus8, L&R) can be inserted with two
effect modules at the same time, which is sequenced to insert into the bus by the priority of selection.
When the selected module is occupied by other channel or bus, you will see a window popped up and say:
“T
he module can be used only once and it is already used by **. Are you sure you want to use the module
forcibly now
?
Yes or No
”
.
EQ subpage
The subpage is the same as the EQ subpage of MIC channels, please refer to the mic channel EQ subpage
Dynamics subpage
The subpage is the same as the Dynamics supage of MIC channels, please refer to the mic channel of
Dynamics page.
