8-12 BODY ELECTRICAL SYSTEM
5) Check the following operation:
a) When pushing “LOCK” button (1) on transmitter (2), check
all doors lock and hazard warning lights flash once.
b) When pushing “UNLOCK” button (3) on transmitter (2),
check all doors unlock and hazard warning lights flash twice
and interior light turn on about 15 seconds with the interior
light switch in the middle position.
If check result is not satisfied, go to “Keyless Entry System Circuit
Inspection” in this section.
Keyless entry system circuit inspection
Check that the voltage and continuity between the following termi-
nals and body ground are specifications under each conditions.
If check result is not as specified, check applicable circuit.
If circuit is normal, recheck keyless entry system circuit as follows.
1) Substitute a known-good door lock controller.
2) Register key code referring to “Code Registration Procedure”
under “Transmitter” in this section.
3) Recheck keyless entry system circuit.
[A]: M13 engine model
[B]: K9K engine model
2
1
3
3
2
1
[A]
[B]
NOTE:
For M13 engine model, if keyless entry system is in inte-
rior light signal mode, change to hazard warning light
signal mode referring to “Change of Signal Mode” in this
section.
[A]: M13 engine model
[B]: K9K engine model
1. Door lock controller
V
1
2
3
4
5
6
7
8
9
10
11
12
1
9
10
11
12
13
14
15
16
17
18
1
2
3
4
5
6
7
8
1
[A]
[B]