ENGINE MECHANICAL (K9K ENGINE) 6A2-51
b) Install camshaft pulley (1) to camshaft with aligning key (3)
of camshaft pulley to key groove (4) of camshaft (2), and
then tighten camshaft pulley nut to temporary.
c) Apply engine oil to sliding surface of each camshaft and
camshaft journal.
d) Fit camshaft to cylinder head and install special tool into
holes of timing belt pulley (1) and cylinder head as shown in
figure.
Special tool
(A): 09919-58120
4) Install camshaft housing to cylinder head as follows.
a) Fit camshaft housing to cylinder head in specified position
as shown.
b) Tighten camshaft housing bolts temporarily by hand.
c) Tighten camshaft housing bolts in numerical order as indi-
cated in figure a little at a time till they are tightened to
specified torque.
Tightening torque
Camshaft housing bolt (a):
Tighten 10 N·m (1.0 kg-m, 7.5 lb-ft) by the specified proce-
dure
5) Install camshaft cover (1) with new gasket.
Tightening torque
Camshaft cover bolt (b):
Tighten 5 N·m (0.5 kg-m, 4.0 lb-ft) and 12 N·m (1.2 kg-m,
9.0 lb-ft) by the specified procedure
6) Connect vacuum pump oil hose (2) to rear camshaft (1)
cover with new gasket.
Tightening torque
Vacuum pump oil hose union bolt (c):
16 N·m (1.6 kg-m, 12.0 lb-ft)
7) Remove camshaft pulley and special tool.
4
3
1
2
"4", (a)
"1", (a)
"2", (a)
"3", (a)
"8", (a)
"5", (a)
"6", (a)
"7", (a)
"12", (a)
"9", (a)
"10", (a)
"11", (a)
1
2
(b)
(c)