BODY ELECTRICAL SYSTEM 8-11
System description
Only for M13 Engine Model
The keyless entry system has the following signal modes in order to feed back the signal when the controller
received LOCK and UNLOCK signals from transmitter.
Change of signal mode
Only for M13 Engine Model
1) Confirm that all doors are closed and ignition key is out of
ignition switch.
2) Perform the following procedures within 15 seconds.
a) Insert ignition key to ignition switch and pull out ignition key
from ignition switch.
b) Repeat step a) two times.
c) Insert ignition key to ignition switch, and then push “LOCK”
button on transmitter more than five times.
3) Confirm that hazard warning light or interior light flash once.
With this, change of signal mode is completed.
Keyless entry system operation inspection
1) Confirm that power door lock system is good condition refer-
ring to “Power Door Lock System Operation Inspection” in
this section.
2) Confirm that turn signal and hazard warning light system is
good condition referring to “Turn Signal and Hazard Warning
Light System” in this section.
3) Check transmitter battery for dead. If battery is dead, replace
battery referring to “Replacement of Transmitter Battery”
under “Transmitter” in this section.
4) Confirm that all doors are closed and unlocked.
Hazard warning light signal
mode
The hazard warning lights flash once.
The interior light flashes twice.
The hazard warning lights flash twice and
the interior light turns on about 15 seconds.
The interior light turns on about 15 seconds.
Interior light signal mode
LOCK signal
UNLOCK signal
Signal mode
Received signal
NOTE:
• These signal modes are able to change referring to “Change of Signal Mode” in this section.
• The initial condition is the hazard warning light signal mode.
NOTE:
For M13 engine model, if keyless entry system is in inte-
rior light signal mode, change to hazard warning light
signal mode referring to “Change of Signal Mode” in this
section.