ENGINE 3-43
• Remove the lower crankcase, and measure the width of com-
pressed plastigauge in the usual manner.
!
!
!
!
!
Crank journal bearing oil clearance
Standard: 0.020 – 0.044 mm
Service Limit: 0.08 mm
• If the width at the widest part exceeds the limit, replace the set
of bearings with new ones by referring to the selection table.
• Check the corresponding crankcase journal I.D. code number
1
, “A” or “B” which are stamped on the rear of upper crankcase.
• Check the corresponding crankshaft journal O.D. code number
2
, “A”, “B” or “C” which are stamped on the crankshaft.
Bearing selection table
Crank pin O.D.
2
Code
A
B
C
Conrod
A
Green
Black
Brown
I.D.
1
B
Black
Brown
Yellow
Crankcase I.D. specification
Code
I.D. specification
A
39.000 – 39.008 mm
B
39.008 – 39.016 mm
Crankshaft journal O.D. specification
Code
O.D. specification
A
35.992 – 36.000 mm
B
35.984 – 35.992 mm
C
35.976
–
35.984 mm
"
"
"
"
"
09900-20202: Micrometer (25 – 50 mm)
Summary of Contents for GSX1200 1999
