6-8 ELECTRICAL SYSTEM
INSPECTION
BATTERY CURRENT LEAK INSPECTION
• Turn the ignition switch to the “OFF” position.
• Remove the seat and document tray
1
.
• Disconnect the battery
_
lead wire
2
.
• Connect the multi circuit tester between the battery
_
terminal
and the battery
_
lead wire as shown in the following illustra-
tion.
NOTE:
Leakage is evident if the reading is over 1mA.
#
#
#
#
#
09900-25008: Multi circuit tester set
$
$
$
$
$
Battery current leak: Under 1mA
%
%
%
%
%
Tester knob indication: Current (
&
&
&
&
&
, 20mA)
"
* Because the current leak might be large, turn the tester
to the high range first to avoid tester damage.
* Do not turn the ignition switch to the “ON” position
when measuring the current.
When checking to find the excessive current leak, remove the
couplers and connectors, one by one, checking each part.
CHARGING OUTPUT INSPECTION
• Remove the seat and document tray. (See above)
• Start the engine, turn the lighting switch to ON and the dimmer
switch to HI and run the engine at 5 000 r/min.
Measure the DC voltage between the battery
+
and
_
terminals
using a multi-circuit tester. If the tester reads under 13.6 V or over
14.4 V, inspect the stator coil, rectifier and IC regulator which are
mounted in the generator.
NOTE:
When performing this test, make sure that the battery is fully-
charged.
#
#
#
#
#
09900-25008: Multi circuit tester set
'
'
'
'
'
Tester knob indication: Voltage (
&
&
&
&
&
)
$
$
$
$
$
Charging output (Regulated voltage)
Standard: 13.6 – 14.4 V at 5 000 r/min.
Battery
-
+
(DCV)
Tester
Summary of Contents for GSX1200 1999
