Suzuki 2010 VZ800L0, Supplementary Service Manual

Page: 15 / 42

14 VZ800L0 (’10-MODEL)
• Refill specified front fork oil up to the top level of the outer
tube again. Move the outer tube up and down several strokes
until no more bubbles come out from the oil.
• Keep the front fork vertically and wait 5 – 6 minutes.
NOTE:
* Always keep oil level over the cartridge top end, or air may
enter the cartridge during this procedure.
* Take extreme care so as to pump out air completely.
• Hold the front fork vertically and adjust fork oil level with the
special tool.
NOTE:
When adjusting the fork oil level, compress the outer tube fully
without the fork spring.

Fork oil level: 153 mm (6.02 in)

09943-74111: Front fork oil level gauge
FORK SPRING
• Install the fork spring as shown in the illustration.
• Install the spring
1
and spacer
2
.
FRONT FORK CAP BOLT
• Pull up the inner rod with the special tool
A
.
• Compress the spring with the special tool
B
and then insert
the special tool
C
between the lock-nut and the spacer.

09940-52841: Front fork inner rod holder
A
09940-94930: Front fork spacer holder
B
09940-94922: Front fork spring stopper plate
C
Upper side
Lower side