59
Set the Image frequency as the upload frame rate. The setting range is
from 1 frame to 15 frames per second.
NOTE:
Make sure SMTP configuration has been completed.
Refer to section
for further details.
Send HTTP Notification
Check this item, select the destination HTTP address, and specify the
parameters for event notifications by <Motion Detection> triggered.
When an alarm is triggered, the notification can be sent to the specified
HTTP server.
For instance, if the custom parameter is set as “action=1&group=2”, and
the HTTP server name is “http://192.168.0.1/admin.php”, the notification
will be sent to HTTP server as “http://192.168.0.1/admin.php?
action=1&group=2” when alarm is triggered.
Record Video Clip
Check this item and select a video recording storage type, <SD Card> or
<NAS> (Network-Attached Storage>. The Motion Detection recording
will be stored in SD card or the NAS when motion is detected.
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is from
1 sec. to 3 sec. Select <Upload for sec> to set the recording duration
after motion is triggered. The setting range is from 1 sec. to 99999 sec.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE:
Please make sure the local recording (with SD card) or
the remote recording (with NAS) is activated so that this function
can be implemented. Refer to section
Recording
for further
details.
