107
9.5.4
Sequence
The Sequence Line Programming can be found under this path:
PTZ>
Sequence
.
The camera supports a total of 8 Sequence Lines; each Sequence Line consists
of up to 64 Preset Points. Please refer to the instructions below to program a
Sequence Line.
NOTE:
Before setting this function, users must pre-define at least two
Preset Points.
Sequence Setting
Please click on the <Edit> button in <Sequence Setting> section to enter the
Sequence setting menu.
Sequence Line
Please select the number of Sequence Line to be set from the drop-
down list in the top of the Sequence setting menu.
Sequential Preset Points Setting
Please setup each Preset Point of the programmed Sequence Line in
order, assigning a Preset Point from the <Name> list for the specified
number of Preset Point and entering both Dwell Time (0 to 127) and
Speed (0 to 14) into the corresponding fields.
When finishing the sequential Preset Points setting, please click on the button
<Save> in the top of the Sequence setting menu.
Sequence Run
Select the specified Sequence Line from the drop-down list, click on the <Go>
button, and then the camera will start moving forward each scene sequentially
as programmed.
To view the camera executing a Sequence Line in full screen mode, please
move the cursor onto the live view pane, right-click and left-click to select
“Fullscreen”. Then users can view the camera navigation in full screen.
To stop running the Sequence Line, simply move the cursor to the live view
pane and move the camera in any direction.