5
INSPECTION FOR DAMAGE
When you receive the dispenser, inspect the exterior of the shipping
container for damage. Note any damage in detail.
Uncrate the dispenser at once (following the instruction sheet inside
the top flaps of the box. These instructions are reproduced below).
Examine the dispenser for damage. Report any damage to the
transportation company immediately. File a claim for damages promptly.
Your immediate inspection protects you against loss since A. C.
Dispensing Equipment Inc. is not responsible for damages incurred during
shipment. Notify A.C. Dispensing Equipment Inc. No returns will be
accepted without prior approval. Obtain an authorized return number by
contacting SureShot Dispensing Systems® Technical Assistance Center at
1-888-777-9990 or 1-902-865-9602.
UNCRATING THE DISPENSER
Caution
: Always lift the dispenser from the bottom.
Do
not
lift the dispenser by the door – that may damage the
dispenser.
To uncrate, follow these instructions:
1. Position the box with the “This Side Up” arrow pointing upward.
2. Turn the dispenser box on its side.
3. Remove the packaging material at the bottom.
4. Install legs by screwing each leg into the bottom of the dispenser.
Tighten by hand until snug.
5. Turn the dispenser box to the upright position.
6. Remove the cardboard box by lifting it up and off. Remember not
to lift the dispenser by the door.
7. Remove the plastic protective covering from the stainless steel
exterior of the dispenser, by peeling it off. To peel, hold the
dispenser firmly at the top and peel from top to bottom.
8. Attach the catch tray to the dispenser.
9. Prior to use, read the Operations Manual. Store it for future use.
NOTE: The box may be stored for future shipping.
RESHIPMENT
Packaging for re-shipment is done in the reverse order of uncrating. If
packaging is not available, it can be purchased locally or from our factory
by request. Any damage occurring in transit of the returned goods caused
by improper packaging is not considered a defect covered by Warranty.
