Sur-Gard SG-System III, Operating Manual

Page: 94 / 131

CHAPTER SIX - SG-DRL3-IP PROGRAMMING
91
SG-System I Operating Manual
6
Option 11: Line Card Number Length
Default (0A)
This option is used to determine how many digits from the line card number will be sent to the output. You also have the option of displaying
the number in hex or decimal. Program this option with one of the following:
Option 12: Debug Output
Default (00)
The debug mode should only be used when required and disabled after use. Enabling the Debug option reduces the SG-DRL3-IP receiver’s
ability to monitor the transmitters.
Options 13 - 14: Transmitter Absent Debounce Time
Default (0078)
The time, in seconds, for which a transmitter configured in supervised mode must be absent before a transmitter failure condition will be
reported. Valid entries are 30-65535 seconds. Value entered in hex.
NOTE: Transmitter Absent Time should not be less than 90 seconds. For ULC Commercial Burg Installations Security

Levels A1 to A4 and ULC Commercial Fire Active communication systems, this option shall be programmed as B4 (180s).
For UL Commercial Burg Installations (standard/encrypted line security), this option shall be programmed as C8 (200s).

For UL Commercial Fire installations (single communication technology) this option shall be programmed as 12C (300s).
Options 15 - 16: Transmitter Restoral Time
Default (003C)
This option determines the required time a transmitter must be present before it is registered in the Account Table and the transmitter restoral
message is sent.
Transmitter Restore Time must be 30 seconds minimum.
NOTE: Two heartbeats must be received from the supervised IP transmitter before the register the restoral of the communi-
cator.

For UL Listed products, the permitted setting is 05AH(90s).
01 Sends only one hex digit to the printer or computer out-
put (if you have a 2-digit line card number only the last
digit will be sent to the output).
02 Sends 2 hex digit line card number to the output.
03 Send 3 hex digit line card number to the output (leading
zeros will be inserted prior to the line card number).
0A Send 3-digit line card number in decimal; send 2-digit
receiver number in decimal
0D Send 3-digit line card number in decimal
00 Disabled
01 Enabled