Supero SUPER 370SSA, User Manual

Page: 41 / 92

Chapter 2: Installation
2-13
Installation
2-8 Parallel Port, AMR, AGP and Floppy/Hard Disk Drive
Connections
Use the following information to connect the floppy and hard disk drive
cables.
• The floppy disk drive cable has seven twisted wires.
• A red mark on a wire typically designates the location of pin 1.
• A single floppy disk drive ribbon cable has 34 wires and two connectors to
provide for two floppy disk drives. The connector with twisted wires always
connects to drive A, and the connector that does not have twisted wires
always connects to drive B.
• The 80-wire ATA66/100 (370SSM/370SSA) IDE hard disk drive cable that
came with your system has two connectors to support two drives. This
special cable should be used to take advantage of the speed this new
technology offers. The blue connector connects to the onboard IDE
connector interface and the other connector(s) to your hard drive(s).
Consult the documentation that came with your disk drive for details on
actual jumper locations and settings for the hard disk drive.
Keyboard Wake-Up
The JPWAKE jumper is used to-
gether with the Keyboard Wake-
Up function in BIOS. Enable both
the jumper and the BIOS setting to
allow the system to be woken up
by depressing a key on the key-
board. See Table 2-20 for jumper
settings. Your power supply must
meet ATX specification 2.01 or
h i g h e r a n d s u p p l y 7 2 0 m A o f
standby power to use this fea-
ture.
J u m p e r
Position
1-2
2-3
Definition
D i s a b l e d
E n a b l e d
Table 2-20
Keyboard Wake-Up
Jumper Settings
(JPWAKE)