Supero SUPER 370SSA, User Manual

Page: 40 / 92

2-12
S
UPER 370SSA/370SSM User's Manual
Installation
AC'97 Enable/Disable
AC'97 brings high quality audio to
PCs. When enabled with JP28, au-
dio is processed onboard and the
AMR slot (370SSM only) will sup-
port modems only. The disabled
setting should be selected when
you wish to use an add-on card
for audio either in the AMR or a
P C I s l o t . S e e T a b l e 2 - 1 8 f o r
jumper settings.
J u m p e r
Position
1-2
2-3
Definition
E n a b l e d
D i s a b l e d
Table 2-18
AC'97 Enable/Disable
Jumper Settings (JP28)
CMOS Clear
Refer to Table 2-17 for instruc-
tions on how to clear CMOS. Al-
ways remove the AC power cord
from the system before clearing
CMOS.
Note: For an ATX power supply, you must
completely shut down the system, remove the
AC power cord, then use JBT1 to clear CMOS.
Replace JBT1 back to the pin 1-2 position be-
fore powering up the system again. Do not
use the PW_ON connector to clear CMOS.
Table 2-17
CMOS Clear Jumper Settings
(JBT1)
J u m p e r
Position
1-2
2-3
Definition
N o r m a l
C M O S C l e a r
Position
1-2
Position
2-3
Normal
CMOS Clear
Wake-On-Ring
The Wake-On-Ring header is desig-
nated as JWOR on the 370SSA and as
JR on the 370SSM. This function al-
lows your computer to receive and be
"woken up" by an incoming call when
i n t h e s u s p e n d s t a t e .
Refer to Table 2-19 for pin definitions.
You must also have a WOR card and
cable to use WOR.
Pin
N u m b e r
1
2
Definition
+ 5 V S t a n d b y
W a k e - u p
Table 2-19
Wake-On-Ring Pin
Definitions (JWOR/JR)