3-2
PDSBM-LN1/PDSBM-LN2/PDSBM-LN2+
User's Manual
NOTE
If you are a system integrator, VAR or OEM, a POST diagnostics
card is recommended. For I/O port 80h codes, refer to App. B.
Memory Errors
1. Make sure that the DIMM modules are properly and fully installed.
2. You should be using unbuffered DDR2 memory (see the next page). Also, it is
recommended that you use the same memory speed for all DIMMs in the
system. See Section 2-4 for memory limitations.
3. Check for bad DIMM modules or slots by swapping modules between slots and
noting the results.
4. Check the power supply voltage 115V/230V switch.
Losing the System’s Setup Confi guration
1. Make sure that you are using a high quality power supply. A poor quality power
supply may cause the system to lose the CMOS setup information. Refer to
Section 1-6 for details on recommended power supplies.
2. The battery on your motherboard may be old. Check to verify that it still supplies
~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fi x the Setup Confi guration problem, contact your
vendor for repairs.
3-2 Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also, note that
as a motherboard manufacturer, Supermicro does not sell directly to end-users, so
it is best to fi rst check with your distributor or reseller for troubleshooting services.
They should know of any possible problem(s) with the specifi c system confi guration
that was sold to you.
1. Please go through the ‘Troubleshooting Procedures’ and 'Frequently Asked Ques-
tion' (FAQ) sections in this chapter or see the FAQs on our website (
http://www.
supermicro.com/support/faqs/
) before contacting Technical Support.
2. BIOS upgrades can be downloaded from our website at
(http://www.supermicro.
com/support/bios/
).
Note:
Not all BIOS can be fl ashed; it depends on the modifi cations to the boot block
code.
3. If you still cannot resolve the problem, include the following information when
contacting Supermicro for technical support:
•
Motherboard model and PCB revision number
•
BIOS release date/version (this can be seen on the initial display when your
Summary of Contents for PDSBM-LN1
