Supero PDSBM-LN1, User Manual

Page: 16 / 95

1-10
PDSBM-LN1/PDSBM-LN2/PDSBM-LN2+ User’s Manual
1-3 PC Health Monitoring
This section describes the PC health monitoring features of the PDSBM-LN1/
PDSBM-LN2/PDSBM-LN2+. The motherboard has an onboard System Hardware
Monitor chip that supports PC health monitoring.
Recovery from AC Power Loss
BIOS provides a setting for you to determine how the system will respond when
AC power is lost and then restored to the system. You can choose for the system
to remain powered off (in which case you must hit the power switch to turn it back
on) or for it to automatically return to a power on state. See the Power Lost Con-
trol setting in the BIOS chapter of this manual to change this setting. The default
setting is Last State .
Onboard Voltage Monitors for the CPU Core, Chipset Voltage,
Memory Voltage, +1.8V, +3.3V, +3.3V standby,
+
5V,
+
5V Standby,
Vbat and
±
12V
The onboard voltage monitor will scan these voltages continuously. Once a voltage
becomes unstable, it will give a warning or send an error message to the screen.
Users can adjust the voltage thresholds to defi ne the sensitivity of the voltage
monitor by using SD III.
Fan Status Monitor with Software
The PC health monitor can check the RPM status of the cooling fans via Supero
Doctor III.
CPU Overheat LED and Control
This feature is available when the user enables the CPU overheat warning function
in the BIOS. This allows the user to defi ne an overheat temperature. When this
temperature reaches the pre-defi ned threshold, the CPU thermal trip feature will be
activated and it will send a signal to the Speaker LED and, at the same time, the
CPU speed will be decreased.
1-4 Power Confi guration Settings
This section describes features of your motherboard that deal with power and
power settings.
Slow Blinking LED for Suspend-State Indicator
When the CPU goes into a suspend state, the chassis power LED will start blinking
to indicate that the CPU is in suspend mode. When the user presses any key, the
CPU will wake-up and the LED will automatically stop blinking and remain on.