Supero 6047R-E1R36L, User Manual

Page: 56 / 112

5-26
S
UPER
S
TORAGE
S
YSTEM 6047R-E1R36L User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
I 2 C to PCI-E Slots
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
I
2
C Bus to PCI-Exp. Slots
Jumpers JI
2
C1 and JI
2
C2 allow you
to connect the System Management
Bus (I
2
C) to the PCI-Express slots.
Both jumpers must be set to the same
setting. See the table on the right for
jumper settings.
GLAN Enable/Disable
JPL1 enables or disables the GLAN
ports on the serverboard. See the
table on the right for jumper settings.
GLAN Enable
Jumper Settings
Jumper Setting De fi nition
1-2 Enabled (default)
2-3 Disabled
Watch Dog Enable/Disable
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if
an application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be
enabled in BIOS.
Watch Dog
Jumper Settings
Jumper Setting De fi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
SAS Enable
Jumper JPS1 allows the user to enable
onboard LSI SAS support. The default
setting is on 1-2 to enable SAS con-
nections 0~3, 4~7. See the table on the
right for jumper settings.
SAS Enable
Jumper Settings
Jumper Setting De fi nition
1-2 Enabled (Default)
2-3 Disabled