Supero 5037A-I, User Manual

Page: 56 / 102

6-4
S
uper
W
orkstation 5037A-I User's Manual
6-3 Front Control Panel
The front control panel must be connected to the JF1 connector on the motherboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection.
Connect the cable from JF1 on the motherboard (making sure the red wire plugs
into pin 1) to the appropriate comnnector on the front control panel PCB (printed
circuit board). Pull all excess cabling over to the control panel side of the chassis.
The LEDs on the control panel inform you of system status - see Figure 6-2 for
details. See Chapter 5 for details on JF1.
Figure 6-2. Front Control Panel LEDs
NIC
HDD
Overheat/Fan Fail
Indicates network activity on the LAN port.
Indicates IDE device and hard drive activity. On the
SC743TQ-1200B-SQ, this LED indicates hard drive activity
when flashing.
When this LED flashes, it indicates a fan failure. When
on continuously it indicates an overheat condition (see
Chapter 3 for details).
1