Supero 5037A-I, User Manual

Page: 45 / 102

Chapter 5: Advanced Serverboard Setup
5-23
LAN Port Enable/Disable (JPL2)
Jumper JPL2 enables or disables LAN
Port 2 on the motherboard. See the table
on the right for jumper settings. The de-
fault setting is pins 1-2 (Enabled).
GLAN Enable
Jumper Settings
Pin# Definition
1-2 Enabled (default)
2-3 Disabled
Watch Dog Reset (JWD1)
Watch Dog (JWD1) is a system monitor
that can reboot the system when a soft-
ware application hangs. Close Pins 1-2 to
reset the system if an application hangs.
Close Pins 2-3 to generate a non-mask-
able interrupt signal for the application
that hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
TPM Support Enable (JPT1)
JPT1 allows the user to enable TPM (Trust-
ed Platform Module) support to improve
data integrity and system security. See the
table on the right for jumper settings. The
default setting is
Enabled .
TPM Support Enable
Jumper Settings
Jumper Setting Definition
1-2 (Default) Enabled
2-3 Disabled
CF Slave/Master
Jumper Settings
Jumper Setting Definition
Open Slave
Closed Master
CF Card Master/Slave (JCF1)
A Compact Flash Card Master/Slave Se-
lect Jumper is located at JCF1. Close this
jumper to enable Compact Flash Card. For
the Compact Flash Card or the Compact
Flash Jumper (JCF1) to work properly, you
will need to connect the Compact Flash-
Card power cable to JWF1 first. Refer tothe
board layout below for the location.
A. TPM Support Enable
B. CF Card Master/Slave Select