Supero 5037A-I, User Manual

Page: 42 / 102

5-20
S
uper
W
orkstation 5037A-I User's Manual
Serial_Link-SGPIO
Pin Definitions
Pin# Definition Pin Definition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
T-SGPIO 1/2 & 3-SGPIO 1/2 Headers
Two T-SGPIO (Serial-Link General Pur-
pose Input/Output) headers are located
next to the I-SATA Ports on the mother-
board. Additionally, two 3-SGPIO ports
(for SAS) are also located next to USB
8/9 . These headers are used to com-
municate with the enclosure manage-
ment chip in the system. See the table
on the right for pin definitions. Refer to
the board layout below for the locations
of the headers.
DOM PWR Connector (JWF1)
The Disk-On-Module (DOM) power con-
nector, located at JWF1, provides 5V
(Gen1/Gen) power to a solid-state DOM
storage device connected to one of the
SATA ports. See the table on the right
for pin definitions.
DOM PWR
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground
Serial Ports
Two COM headers (COM1 & COM2)
are provided on the motherboard. The
COM1 and COM2 headers are located
next to the expansion slots to provide
onboard serial connection support. See
the table on the right for pin definitions.
Serial Ports-COM1/COM2
Pin Definitions
Pin # Definition Pin # Definition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 N/A
A. Overheat/Fan Fail LED
Overheat/Fan Fail LED (JOH1
)
The JOH1 header is used to connect an
LED to provide warnings of chassis over-
heat. This LED will also blink to indicate a
fan failure. Refer to the table on right for
pin definitions.
Overheat LED
Pin Definitions
Pin# Definition
1 5vDC
2 OH Active
OH/Fan Fail LED
Pin Definitions
State Message
Solid Overheat
Blinking Fan Fail