Supermicro SUPERSERVER 6013A-T, User Manual

Page: 13 / 126

Chapter 1: Introduction
1-3
Memory
The X5DPA-TGM+ has four (4) 184-pin DIMM sockets that can support up to 8
GB of registered ECC DDR-266/200 SDRAM modules. Low-profile memory
modules are required for use in the 1U form factor of the 6013A-T. Module sizes
of 128 MB, 256 MB, 512 MB and 2 GB may be used to populate the DIMM slots.
(The X5DPA-TGM+ was designed to support 2 GB DIMM modules in each memory
slot, but it has only been validated with 1 GB memory modules.)
Serial ATA
The ICH5R hub supports a two-port Serial ATA subsystem, which is RAID 0 and
RAID 1 supported. The Serial ATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
PCI Expansion Slots
The X5DPA-TGM+ has five 32-bit, 33 MHz PCI slots, one of which is available in
the 6013A-T 1U configuration. One riser card is included with the system for use
with a 32-bit PCI card.
Ethernet Ports
The X5DPA-TGM+ features Intel's 82541 and 82550 Ethernet controllers, which
support one Gb LAN port and one 10/100 Mb LAN port, respectively.
Onboard Controllers/Ports
An onboard IDE controller supports one floppy drive and up to four* Ultra ATA 100
hard drives or ATAPI devices. Onboard I/O backpanel ports include one COM
port, a VGA port, two USB ports, PS/2 mouse and keyboard ports, a Gb LAN and
a Mb LAN port. (*Only two IDE drives can be housed in the chassis.)
Other Features
Other onboard features that promote system health include eight voltage moni-
tors, a chassis intrusion header, auto-switching voltage regulators, chassis and
CPU overheat sensors, virus protection and BIOS rescue.