Supermicro SUPERSERVER 6013A-T, User Manual

Page: 112 / 126

C-10
S
UPER
S
ERVER 6013A-T User's Manual
Notes
1. Before adding a new drive to an array, back up any data contained on
the new drive. Otherwise, all data will be lost.
2. If you stop the Build or Clear process on a RAID 1 from ACU, you can
restart it by pressing Ctrl+R.
3. A RAID 1 disk created using the Quick Init option may return some data
miscompares if you later run a consistency check. This is normal and is not
a cause for concern.
4. The ACU allows you to use drives of different sizes in a RAID. However
during a build operation, only the smaller drive can be selected as the
source or first drive.
5. When migrating from a single volume to RAID 0, migrating from a larger
drive to a smaller drive is allowed. However, the destination drive must be
at least half the capacity of the source drive.
6. Adaptec does not recommend that you migrate or build an array on
Windows dynamic disks (volumes), as it will result in data loss.
Warning : Do not interrupt the creation of a RAID 0 using the Migrate option.
If you do, you will not be able to restart or recover the data that was on the
source drive.