Shenzhen SUNSKY Technology Limited
31
For master and families
：
#09#
For guest
：
#09#password#
Camera will reply two SMS including normal commands as following:
Active equipment: #00#
Set defense: #01#Password#
Cancel defense: #02#password#
Require image quantity: #03#password#quantity#
Change password: #04#old password#new password#
Loaded sensor: #05#sensor description#
Added family: #06#number#
Check status: #07#password#
Recover defeat setting: #08#password#
Get detail instruction:
User send following SMS command to camera:
For master and families
：
#09#1#
For guest
：
#09#password#1#
Camera will reply “V900 user manual” by MMS to user’s cell phone.
23. Reset the camera
(Authority: Master)
If the remote camera setting is wrong, or fail to work even after restarting the camera. The
following operation will enable the remote camera restore to the factory setting (clear of all
users’ setting), and resume to regular work status:
Method 1: Power off the camera, cut off the power for more than 20 seconds. Press and hold
the setting key at the rear of the camera, switch on the camera , release the setting key when
a “DI” tone can be heard. (The indicator will lighten constantly for 2-4seconds,then flash
slowly in red color when a “DI” tone sounded, which indicated restoring factory setting
successfully.)
Note: After resetting the camera, the remote control is needed to reload. See “Chapter 5,
Advanced Operation, 7 add / delete remote control” operation.
Method 2
：
Master sends following SMS command to camera:
#08#password#
