Suburban Dynaline 3 A&E Manual 12/2016 Rev.1
29
Connecting Dynaline
™
3 to a Standby Generator
A Dynaline
™
3 feature of particular importance to the nursing home/assisted
living industry is its low amp draw in the heating cycle, made possible by
its high efficiency gas heating. This creates an opportunity for the facility
to install a smaller, less costly standby emergency power generator, without
forfeiting zone temperature control on the heating cycle.
Dynaline 3 incorporates an A/C compressor lock-out capability.
This feature allows the compressor circuit to be locked out when facility
power is supplied by a standby emergency power generator. This is done
by routing 24-volt lead wires from a 208/230/24 V.A.C. transformer
(NOTE: Field supplied transformer to be powered by the standby generator.)
to the 1/4" spade terminals on the module board. (See
Figure 29
for
Ladder Diagram of typical standby generator electric service.)
Figure 29
Summary of Contents for DYNALINE DL3-0712
Page 16: ...Suburban Dynaline 3 A E Manual 12 2016 Rev 1 16 Figure 12...
Page 26: ...Suburban Dynaline 3 A E Manual 12 2016 Rev 1 26 Figure 26 Ladder Diagram 208 230 V A C...
Page 27: ...Suburban Dynaline 3 A E Manual 12 2016 Rev 1 27 Figure 27 Schematic 277 V A C...
Page 28: ...Suburban Dynaline 3 A E Manual 12 2016 Rev 1 28 Figure 28 Ladder Diagram 277 V A C...
