Suburban DYNALINE DL3-0712, Architects And Engineers' Manual

Page: 13 / 40

Suburban Dynaline 3 A&E Manual 12/2016 Rev.1
13
1. Unfold the sides of the wall sleeve and assemble the top, so that the
sides wedge between the top flange and the retaining angle. (See
Figure 8. ) Apply 4 screws provided to secure top to the sides.
2. Cut an opening in the outside wall and frame to minimum opening.
(See Figures 6 & 7 .)
3. Install wall sleeve into framed opening. Be sure that the bottom of wall
sleeve is resting firmly on the bottom framing member since the weight
of the unit rests solely on the bottom of the wall sleeve. Failure to
support the bottom of the wall sleeve could pull the sides away and
result in water leakage on the floor.
4. Secure the wall sleeve to the wall as shown in
Figures 9 & 10 . Be sure
wall sleeve has a 1/4" slope to the outside. Do not slope toward front!
To avoid water damage to the wall, do not put holes through the
bottom of the wall sleeve.
NOTE: If the unit is to be mounted flush with the exterior wall, wall
sleeve must protrude beyond the finished exterior wall a minimum of 1/4".
If rear gas connection, sleeve must extend beyond the finished exterior wall
surface 1-5/8”. (See Figures 9, 10, & 11 .)
5. Trim around the wall sleeve with moulding or other suitable material.
(See Figures 9, 10, & 11 .)
6. Install the grille with louvers angled in the downward position, as
shown in Figures 9, 10 & 11.
NOTE: Outside rear grille must be installed prior to installing chassis.
NOTE: Do not discard packing inside carton. It may be used as a
temporary cover for weather and construction protection. To cover the wall
sleeve opening, cut cardboard insert along the perforated line, fold and place
in rear of sleeve.
INSTALLING THE
WALL SLEEVE
KNOCKDOWN WALL SLEEVE
Figure 8