Stryker 1688 Series, Manual, Page: 51 / 68

47
Note:
See the Materials and Equipment table for validated detergents
with their minimum concentration.
3. Gently mix the detergent into the water by hand.
4. Submerge the device into the prepared wash basin.
5. With the device immersed in the solution, thoroughly brush the exterior
with a soft-bristled brush, focusing on any mated or rough surfaces.
6. Actuate and brush any movable parts in all extreme positions.
7. Rinse each device with water until all detergent residue is removed.
8. Once all detergent residue is removed, continue to rinse for 30 seconds.
9. Drain excess water from the device and dry it using a clean cloth or
pressurized air.
10. Visually inspect each device for cleanliness, paying close attention to
hard-to-reach areas. If visible soil remains, repeat steps 1– 10.
Manual Cleaning
1. Prepare a fresh solution of detergent with lukewarm water.
Note:
See the Materials and Equipment table for validated detergents
with their minimum concentration and soak time.
2. Wipe the entire surface of the device using a soft clean cloth dipped in
the detergent solution.
3. Immerse the device in the detergent solution, ensuring the solution
contacts all inner and outer surfaces.
4. Soak the device in the solution according to the manufacturer’s
recommendations.
5. With the device immersed in the solution, thoroughly brush the exterior
with a soft-bristle brush, focusing on any mated or rough surfaces.
6. Actuate and brush any movable parts in all extreme positions.
7. Rinse each device with water until all detergent residue is removed.
8. Once all detergent residue is removed, continue to rinse for 30 seconds.
9. Drain excess water from the device and dry it using a clean cloth or
pressurized air.
10. Visually inspect each device for cleanliness, paying close attention to
hard-to-reach areas. If visible soil remains, repeat steps 1– 10.
Automated Cleaning
The device cannot withstand an automated disinfection
method. When programming the washer, do not include a
thermal rinse cycle or the device will be damaged.