Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–42
DOC-06800 Rev. A
Replacing the
UV Lamps
The UV lamps used for curing models have a long, but limited, working
life. The Stratasys service engineer tests their effectiveness during regular
maintenance checks, and replaces them, if necessary. You can test and
adjust their effective power with the UV Calibration Wizard (see Testing
and Calibrating the UV Lamps on page 36. If you need to replace a UV
lamp, follow these instructions:
1. Make sure the printer is in
offline
mode.
Figure 6-56: Offline mode indicator (red)
The
online/offline
button at the bottom of the printer interface should be
red. If not, click it to switch the printer to
offline
mode.
2. Start the UV Lamp Replacement Wizard from the
Options
menu (see
figure 6 24 on page 25).
3. Make sure that the build tray is empty, and confirm this in the wizard
screen. Then, close the printer cover and click
Next
.
Figure 6-57: “Empty tray” confirmation screen
The axes move to the home position.
WARNING: Before continuing, make sure that the safety interlock is not
defeated, and that the lamp is not hot.
D R A F T
16 June 2013
Summary of Contents for Objet1000 Connex 2
