Stratasys Objet1000 Connex 2, User Manual, Page: 151 / 174

DOC-06800 Rev. A
6–31
Objet1000 - Connex 2 User Guide
6. Place the new scraper blade onto the pins in the holder, as shown.
Figure 6-37: Inserting the new roller scraper blade
7. Insert and tighten the roller scraper blade screws.
Figure 6-38: Tightening the roller scraper screws
8. After tightening the screws, inspect the blade and make sure that it is
straight. If necessary, loosen the screws and tighten them again, evenly.
9. Return the roller waste collector assembly and the right UV lamp to
the print block. See steps 6 to 10, from page 6 29.
Important:
•
Tighten the screws in the order shown in figure 6-38.
•
Use the new screws supplied in the replacement kit.
D R A F T
16 June 2013