FP12 Mundo - Installation and Operation Manual
31
The gasket must be centred on the edge of the glass. To do this easily, peel back a section of the paper
covering the adhesive and place the gasket on a table with the adhesive side up. Stick the end of the gasket
to the middle of top edge of the glass, then press the edge of the glass down onto the gasket, taking care
that it is perfectly centred on the gasket. Peel off more of the backing and press the whole length of the
edge of the glass onto the gasket. Do not stretch the gasket as you place it. Cut to the necessary length.
Now pinch the gasket to the glass in a U shape over the front and back of the glass. Do the same for the
bottom edge of the glass.
Location
Length
Dimensions
Around glass
31 1/8" (79 cm) (2X)
“U” shaped self-adhesive
Behind the glass
90" (229 cm)
Flat, self-adhesive (1/8" X 1")
An other glass gasket is located at the back of the glass. When replace in the glass or as needed, install
according to following illustrations.
