StorageTek Host Software Component 6.0, System Programmer'S Manual

Page: 358 / 718

328 VM/HSC 6.0 System Programmer’s Guide
1st ed., 6/30/04 - 312579601
Utility Name
VOLRpt
specifies that a volume report is to be produced.
Parameters
ACS
optionally specifies that a report is to be produced for only a particular ACS.
(acs-id)
The one or two digit hexadecimal ACS identifier.
LSM
optionally specifies that a report is to be produced for only certain LSMs within an
ACS.
(lsm-list)
lsm-list indicates the LSMs. An lsm-list can be a single LSMid or a list of
LSMids. An LSMid ( lsm-id ) is made up of the ACSid (hexadecimal 00-FF) and
the LSM number (hexadecimal 00-17) separated by a colon (:).
An LSM range is not allowed. If a list is specified, the elements must be
separated by blanks or commas, and the entire list enclosed in parentheses.
VOLser or VOLume
optionally specifies that the report only contain information on certain VOLSERs.
(volser or vol-range or vol-list)
volser , vol-range , and vol-list indicate the volume serial numbers requested.
Any subranges of volumes specified in the vol-list that are not in the control
data set are listed in the Control Card Image Listing portion of the report using
one line per subrange.
A percent sign (‘‘%’’) may be used as a ‘‘wildcard’’ character in the VOLSER
to specify pattern matching. The percent sign designates that any single
character can match the corresponding position in the VOLSER.
For example, A9%%%% specifies that all of the six-character volume serial
numbers that begin with the characters ‘‘A9’’ are selected for the report.
Q%12% specifies that all five-character VOLSERs that begin with ‘‘Q’’ and
have a ‘‘12’’ in the third and fourth positions of the VOLSER are selected for
the report. The percent sign cannot be specified in a range specification.
Therefore, ‘‘A%0000-A%9999’’ is invalid.
In the Volume Report Listing of the utility, the volumes requested which are not
in the control data set are not listed.
Volume Report